Sanand, Ahmedabad, Gujarat
MOQ : 50 Piece
Business Type : Exporter, Supplier
Technical data
Sensor | inductive |
Nominal width | DN 10 (RRI-010), DN 25 (RRI-025) |
Pressure resistance | PN 16 bar |
Medium temperature | 0..60 °C |
Materials, nonmedium- contact | PVC cable, 1.4305, 1.4301, CW614N nickelled |
Current consumption at rest | 10 mA / NAMUR max. 7 mA |
Output current max. | 200 mA / NAMUR max. 7 mA |
Electrical connection Sensor | cable 2 m or for round plug connector M12x1, 4-pole |
Resistant to short circuits | yes |
Reversal polarity protected | yes |
Ingress protection | IP 67 |
Conformity | CE |
Make | Honsberg |
Download | ![]() |
Preferred Buyer From
Location | Worldwide |
Flow Transmitter RRI :
Characteristics : The flow meter consists of a spinner which is rotated by the flowing medium. The rotor's rotational speed is proportional to the flow volume per unit time. The rotor is fitted with stainless steel clamps (optionally titanium or Hastelloy. An inductive proximity switch records the rotational speed, which is proportional to the flow rate.
Wiring : the valve should be installed behind the sensor. A running up time of approx. 0.5 seconds and a running down time of approx. 3 seconds should be noted.
Handling and operation
The Rototron device is installed in the pipework with the aid of the rotatable adapter pieces. If necessary, the adapters can be removed from the body of the housing after the stainless steel clips have been removed from the housing. Before reinstalling, it should be ensured that both the adapter with the O-ring and the sealing surface in the body are clean and undamaged. The adapters should be fitted carefully in the housing (it is best to turn them), so that the O-ring is not damaged. With this flow sensor, there is no need for run-in and run-out sections. However, it should be ensured that the flow sensor is at all times filled with medium. Any preferred installation position is possible, but the best possible venting position should be chosen (rotor axis horizontal, flow horizontal or from bottom to top). Air bubbles affect the measurement results. For filling processes
Options : Rotor with titanium clamps
Accessories :